Formax FD 8400HS 유지 관리 매뉴얼 - 페이지 4

{카테고리_이름} Formax FD 8400HS에 대한 유지 관리 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Formax FD 8400HS 14 페이지. High security shredder cross-cut
Formax FD 8400HS에 대해서도 마찬가지입니다: 운영자 매뉴얼 (2 페이지)

페이지 인쇄

Operation

1. Open the door and turn the circuit breaker switch to "ON" (see page 12). Close door. Flip ON/OFF button

(right side of cabinet, see page 3) to "ON".

2. Auto Start/Auto Stop

Press the "START" button. The signal lamp "AUTO" will light. Insert paper to shred. The shredder will start and

stop automatically when using this function.

3. Manual Operation

If paper is too small for the shredder's sensors to detect, shred it manually. Push the "START" button once

more and the "MANUAL" lamp will light. Insert paper to be shredded. Three minutes after shredding, the cutter

automatically stops rotating.

4. Reverse Operation

Push the "REV" button. The signal lamp "REV" will light and cutters will operate in reverse. If too much paper

is inserted at one time in standard modes, the shredder will automatically operate in reverse. If this occurs,

remove the inserted paper and shred in smaller amounts. NOTE: The maximum amount of paper to be

shredded differs according to paper quality, humidity and voltage. If the shredder is to be used continuously, do

not insert more than half of the maximum capacity.

5. Full Sensor

If the waste bin is full, the "FULL" lamp will light and the cutter will stop automatically. Open the door, empty the

waste bin of paper shreds, replace the waste bin, close door, press "START" and continue to shred.

Safety Devices & Other Features

Automatic Reverse Rotation

When too much paper is inserted, the cutter stops operating and automatically rotates in reverse to discharge

the jammed paper. An alarm sounds. Reduce the amount of paper and restart the operation.

Door Switch

If the door is open, the shredder will not operate.

Automatic Stop

When the waste bin is full of shredded material, the "FULL" light comes on and the cutter stops operation.

Open the door, remove the waste bin and empty paper scraps. Replace the waste bin, close the door and

continue operation.

Automatic Power Shut-Off

• If the shredder operates continuously for more than 30 minutes, the power is automatically shut off.

• If the motor is overloaded, the "STOP" LED will flash until it cools down. When the flashing stops the

shredder is ready to be used again.

Oil Indicator

Oil regularly for peak performance. NOTE: High Security shredders require a specialized oil that can only be

ordered through Formax, part # 8000-15.The "MANUAL" LED will flash after every four (4) hours of operation

as an indicator to oil the shredder cutting blades. The LED will continue to flash until oiled. NOTE: the

shedder will still operate when the LED is flashing but at a decreased load capacity.

To oil: Spread shredder oil onto the cutters through the feed opening, and allow the oil to sit for a few minutes

to permeate the cutting blades, then press the "REV" button and hold for five seconds. "MANUAL" and "REV"

LED indicators on control panel will light. The shredder will operate in reverse for one minute, then the "AUTO"

LED will light indicating the shredder is ready.