Electrolux EHTAROW 사용자 설명서 - 페이지 6

{카테고리_이름} Electrolux EHTAROW에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Electrolux EHTAROW 16 페이지.

페이지 인쇄

Power supply 400...415V 3N

Figure 9

Open the power supply terminal board and insert the

jumpers provided as follows: one jumper between termi-

nals 2 and 4 and another between terminals 4 and 6.

Using a suitable power supply cable (see technical data

table), connect the three phases to terminals 1, 3 and 5,

the neutral to terminal 6 and the earth wire to the termi-

nal

Power supply 220...240V 3

Figure 10

Open the power supply terminal board and insert the

jumpers provided as follows: one jumper between termi-

nals 1 and 2, one between terminals 3 and 4 and

another between terminals 5 and 6. Using a suitable

power supply cable (see technical data table), connect

the three phases to terminals 1, 3 and 5 and the earth

wire to the terminal

Power supply 220...240V 1N

ATTENTION

Reduce the power of the boiler from 12 kW to 6kW

by connecting the resistors as shown in the circuit

diagram.

Figure 11

Open the power supply terminal board and insert the

jumpers provided as follows: two jumpers between ter-

minals 1, 3, 5 and another two between terminals 2, 4

and 6. Using a suitable power supply cable (see techni-

cal data table), connect the phase and neutral to termi-

nals 5 and 6 respectively and the earth wire to the

terminal

Connections provided for energy control

This appliance is designed for an external energy con-

sumption control.

Figure 12

Connect the energy peak controller across terminals

11 and 12.

CAUTION

A normally open (n.o.) contact of the

controller must be connected across

terminals 11 and 12. When this contact

closes the boiler heating elements are

disconnected. Using the dishwasher in

these conditions may increase the cycle

time.

Safety devices

•

An automatic reset thermal over-heat device incor-

porated in the windings of the electric pump cuts off

the electricity supply in the case of malfunctioning.

•

In the event of water mains failure, a device pre-

vents water in the boiler from returning into the

mains.

•

An overflow pipe, connected to the drainage outlet,

maintains the water in the tank at a constant level.

Failure to comply with safety rules and regulations

relieves the manufacturer of all liability.

WARNING MESSAGES DISPLAYED ON THE

CONTROL PANEL

NO WATER

Check that the cock is open.

Check that the water inlet filter is clean.

Check the minimum mains pressure.

Check that the overflow pipe is inserted.

INEFFICIENT DRAINAGE

Check if the overflow has been removed.

Check for obstruction on the waste outlet pipe and

the overflow aperture.

TANK WATER LEVEL TOO HIGH

Check for obstruction on the waste outlet pipe and

the overflow aperture.