Formax FD 8502AF 유지 관리 매뉴얼 - 페이지 12

{카테고리_이름} Formax FD 8502AF에 대한 유지 관리 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Formax FD 8502AF 19 페이지. Autofeed shredder
Formax FD 8502AF에 대해서도 마찬가지입니다: 운영자 매뉴얼 (2 페이지)

페이지 인쇄

Shredder motor and blades

continue to rotate

Reverse function will not work

Shredder makes an unusual or

metallic noise

Motor makes a "tick tick" noise

Check control panel lights to see if

AUTO lamp is flashing

Check control panel lights to see if

MANUAL lamp is on

Photo sensor could be dirty

Photo sensor sensitivity may need to be

reset

Check power relay contacts

Check power relay contacts (in case of

electrical coil damage)

Check printed circuit for damage

Check cutters for materials lodged be-

tween cutting blades and/or guides

Check guides and cutters for damage

(pages 10& 11)

Check bearings, space rings and cut-

ting shafts for damage (pages 10 & 11)

Check the reduction gears for damage

(page 5)

If so, follow instructions for Sensor

Sensitivity Recovery (page 4)

If yes, press the START button. AUTO lamp

should light and shredder should operate in

AUTO mode.

Remove photo sensor (page 14) and clean

it with a soft cloth

Sensitivity measurement distance should be

.4 inch (10mm). If distance is less than .4

inch, replace the photo sensor

Reconnect, or replace main PCB power

relay if necessary

Replace power relay

If damaged, replace the Main PCB

If so, turn off shredder and carefully remove

any foreign materials from the cutter. Then

follow instructions for Auto Cleaning (page

If guides and/or cutters are broken, the

whole cutting head should be replaced

If any of these parts are damaged, they

should be replaced, in addition to side

plates

If the reduction gears are broken,

replace the entire motor