Formax FD 8650CC 운영자 매뉴얼

{카테고리_이름} Formax FD 8650CC에 대한 운영자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Formax FD 8650CC 2 페이지. Autooiler cross cut paper shredder

Safety Devices and Other Features

Formax 8000 Series Shredders are equipped with various safety features:

Automatic Reverse Rotation

When too much paper is inserted, the cutter stops operating and

automatically rotates in reverse to discharge the jammed paper. An alarm

sounds. Reduce the amount of paper and restart the operation.

Door Switch

If the door is open, the shredder will not operate.

Automatic Stop

When the shredded paper fills the wastebasket, the "FULL" light comes on

and the cutter stops operation. Open the door, remove the wastebasket and

empty paper scraps. Replace the wastebasket, close the door and continue

operation.

Automatic Power Shut-Off

• If the shredder operates continuously for more than 30 minutes, the power

is automatically shut off.

• If the motor is overloaded, the "STOP" LED will flash until it cools down.

When the flashing stops the shredder is ready to be used again.

Maintenance

• Disconnect power by pulling power cord plug from wall outlet.

• To clean the exterior, wipe the surface with a soft cloth. If the surface is very dirty, use a

neutral detergent, then wipe again with a soft cloth.

CAUTION:

• Never put water directly on the surface of the shredder.

• Never clean the case with benzene or thinner, since it will cause discoloration.

• Do not dismantle the shredder. Contact your Formax Dealer for service.

FD 8650CC AutoOiler

Cross Cut Paper Shredder

8/2010

OPERATOR MANUAL

FIRST EDITION