Formax FD 8650HS 운영자 매뉴얼

{카테고리_이름} Formax FD 8650HS에 대한 운영자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Formax FD 8650HS 2 페이지. High-security w/autooiler cross-cut paper shredder

Safety Precautions, continued

• Do not allow children to use the machine.

• Do not operate with a damaged power cord or plug, or when the machine is damaged

in any manner.

• Unplug the shredder when it is being moved, or if it is not in use for an extended

period of time.

• Do not disconnect the power by pulling only the cord. Hold the plug when

disconnecting.

• Keep the shredder away from direct sunlight.

• Do not sit on the shredder or place anything on top of it.

• Never open the fixed switch or cover.

Safety Devices and Other Features

Automatic Reverse Rotation

When too much paper is inserted, the cutter stops operating and

automatically rotates in reverse to discharge the jammed paper.

The shredder will beep. Reduce the amount of paper and restart the

operation.

Door Switch

If the door is open, the shredder will not operate.

Automatic Stop

When the waste bin is full, the "FULL" LED will light and the cutter stops

operation. Open the door, remove the waste bin and empty. Replace

the waste bin, close the door, and press START to resume operation.

Automatic Power Shut-Off

If the shredder operates continuously for more than 30 minutes, the

power is automatically shut off.

If the motor is overloaded, the "STOP" LED will flash until it cools down.

When the flashing stops the shredder is ready to be used again.

Maintenance

• Disconnect power by pulling power cord plug from wall outlet.

• To clean the exterior, wipe the surface with a soft cloth. If the surface is very dirty, use a

neutral detergent, then wipe again with a soft cloth.

CAUTION:

• Never put water directly on the surface of the shredder.

• Never clean the case with benzene or thinner, since it will cause discoloration.

• Do not dismantle the shredder. Contact your Formax Dealer for service.

FD 8650HS High-Security w/AutoOiler

Cross-Cut Paper Shredder

NSA Approved: Meets the requirements of NSA/CSS specification

for Level 6 High-Security cross-cut shredders.

4/2015

OPERATOR MANUAL

SECOND EDITION