Formax FD 540 운영자 매뉴얼 - 페이지 9

{카테고리_이름} Formax FD 540에 대한 운영자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Formax FD 540 17 페이지. Burster

FORM SET-UP PROCEDURE

1. Without table, machine should be positioned on an ordinary

table with the Slitter Unit overhanging the edge. This will allow

the paper edge trim to be directed into any type of basket placed

under the Slitter Unit.

2. Measure the form length with the form length scale on the

Infeed Cover. (See top photo in Operation, General section for

location of Form Length Scale.)

3. Set the machine for the length of the form by pulling Carriage

Adjustment Knob outward- andr.ota.te it so that the Alignment

Mark on the Feed Roller Cover aligns with the corresponding

form length of the Form Setting Indicator. Push the knob back in.

(Fig. 8)

4. Push the paper guides apart.

5.Thread the form under the infeed rod, over the

paper table and under the iinfeed brush.

6. Lightly press the infeed brush so that it rests lightly on the

form. (Fig. 9)

7. Center the leading edge of the form at the infeed end of the

machine so that the outer edges of the form extend equally

beyond the Guide Wires Indicators on each side, If you ﬁnd that

the edges come within about 1/4" of the Guide Wires, offset the

form in either direction to avoid this. (Fig. 9)

8. Push the paper guides so that they are approximately 1/16"

from the edge of form.

NOTE: For Models with slitters or tractors see Fig. 14.

9. Using the Handwheel, guide the form thru until the Snap

Roller grabs the form. (Fig. 10)