Ancom IDAG065X09-A0 빠른 시작 매뉴얼 - 페이지 2

{카테고리_이름} Ancom IDAG065X09-A0에 대한 빠른 시작 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Ancom IDAG065X09-A0 2 페이지. Wide-band directional mimo antenna

Model Number:

Wide-band Directional MIMO Antenna, X-pol, 698-960/1710-2700MHz, 6-10dBi

Thanks for choosing our product! Before exciting installation, please read this guide carefully.

 Make sure qualified personnel are hired for installing this product such as working at height

with safety awareness, tools operating skills, and etc.

 This is low PIM designed product and be gentle to bend the jumper cable and fasten the

connectors.

 Please check the items against the below packing list and make sure the product is in good

condition without any damage and none is missing.

 Check the necessary installation tools below are prepared on site before the installation.



Find proper position and the flat surface of wall to mount this antenna based on the

coverage design and planning documents.

STEP1:

Mark the 4 drilling points by Mounting

Plate at the desired position on the wall. Drill 4

holes on the wall and tap the 4 plastic plugs

into them. Fix the Mounting Plate by screwing

the 4 tapping screws into the plastic plugs.

STEP3:

Joint the connectors with systems.

Packing List

Antenna

Mounting Plate

St 4*25 Tapping Screw

6mm Plastic Plug

QC Check

*In pursuance of continual product improvement, the right to change specifications without prior notice is reserved.

Rev:2016-0-8i

IDAG065X9-Ax (x=0, 2 for PIM3 value)

Note for Installation

Mounting Instruction

STEP2:

Place the Antenna on the Mounting Plate

and make sure the antenna is securely hooked up

on the Mounting Plate.

Percussion Drill andΦ6mm bit

Phillips Screwdriver

2/2

List of Installation Tools