Formax Cut-True 29A 프로그래밍 매뉴얼 - 페이지 12
{카테고리_이름} Formax Cut-True 29A에 대한 프로그래밍 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Formax Cut-True 29A 17 페이지. Guillotine cutters
페이지 인쇄
options - special functions, eject
Touch to change the value
Eject can be set in inches or mm. It is the value by which the paper stack moves forward at the end of a cycle. After each
cycle, the back gauge returns to the previous position. Enter the value, then press ReTURn.
options - language
To set, choose a language, then press ReTURn.
options - base Dimension Correction
Base Dimension Correction allows for re-calibration without turning off the power, and optional correction of dimension (if
displayed dimension does not correspond to real, measured dimension).
When starting the cutter, measure the cut paper and compare that measurement with the on-screen display. If both dimen-
sions do not match, the operator must adjust the base dimension, following these steps:
•
Move the back gauge into position (for example, 11")
•
Cut the paper
•
Measure the size of the cut sheet
•
If the measured size is 10.5", the operator should change the dimension by increasing the value
(difference between screen size and "real" measured size), which would be .5" in this example.
•
If the measured size is 11.25", the operator should change the dimension by decreasing the
value, which would be .25" in this example.
8
Touch to change the value
Touch to exit this mode