Formax FD 87HD 운영자 매뉴얼
{카테고리_이름} Formax FD 87HD에 대한 운영자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Formax FD 87HD 2 페이지. Hard drive punch
Formax FD 87HD에 대해서도 마찬가지입니다: 유지 관리 매뉴얼 (14 페이지)
페이지 인쇄
Safety Devices and Other Features
The FD 87HD is equipped with various safety features:
Automatic Reverse
If the hard drive cannot be punched, the motor will automatically switch into reverse to
prevent damage to the punching die.
Door Open / Safety Shield Open
If the door or safety shield is open, the machine will not operate. Close
the door or safety shield and press start to resume punching.
Waste Bin Full
When the waste bin is full of punched hard drives, a weight sensor will
activate the "FULL" light on the control panel. Open the door, remove
the waste bin and empty it. Replace the waste bin, close the door and
continue operation.
Maintenance
• Disconnect power by pulling power cord plug from wall outlet.
• To clean the exterior, wipe the surface with a soft cloth. If the surface is very dirty, use
a neutral detergent, then wipe again with a soft cloth.
CAUTION:
• Never put water directly on the surface of the machine.
• Never clean the case with benzene or thinner, since it will cause discoloration.
• Do not dismantle the machine. Contact your Formax Dealer for service.
Troubleshooting
If the hard drive punch will not operate, check the following:
Is the machine plugged in?
Is the power switch in the ON position? Switch power to ON.
Is the safety shield open?
Is the cabinet door open?
Is the waste bin full?
Plug machine into appropriate outlet.
Close safety shield.
Close cabinet door.
Empty bin, replace and close door.
FD 87HD
Hard Drive Punch
2/2014
OPERATOR MANUAL
FIRST EDITION