Electrolux ESF 2420 지침서 - 페이지 10

{카테고리_이름} Electrolux ESF 2420에 대한 지침서을 온라인으로 검색하거나 PDF를 다운로드하세요. Electrolux ESF 2420 16 페이지. Dishwasher
Electrolux ESF 2420에 대해서도 마찬가지입니다: 지침서 (20 페이지)

페이지 인쇄

Using the appliance

Starting the programme

1. Scrape or rinse off solid food remnants.

2. Load the dishwasher.

(See the basket and loading).

3. Put the correct amount of detergent into the

detergent dispenser and close the dispenser lid.

4. Close the door.

5. Select the required programme (see programme

chart). The programme indicator lamps starts to

ﬂash.

6. Press in the start button. The lamp for the start

button comes on and dishwashing cycle starts.

The programme indicator lamps allways indicates

which part of the selected cycle the dishwasher

is in.

7. Check the ﬁlters to see if they need to be

cleaned when the dishwasher has ﬁnished

the programme.

Disrupt the programme temporarily

1. Open the door. The programme stops.

2. Close the door and the programme continues

after about six seconds.

Open the door carefully when the dishwasher

is running, since hot steam may escape.

Cancelling the programme

1. Press and hold in the start button until the lamp

for the start button goes out.

2. Release the button, the programme indicator

lamps starts to ﬂash.

3. Turn the programme selector to the "Reset"

position. The programme is now cancelled and

a new programme can be selected.

If you simply turn the programme selector to the

"Reset" position, the selected programme is not

ﬁnished, it is only disrupted. The programme will

continue if you turn the programme selector to

the programme again.

Cancelling the drying phase

In case you do not want to wait until the drying phase is

completed, you can cancel it.

1. Press and hold in the start button until the

programme indicator lamps starts to ﬂash,

then kan you release the button.

2. Open the door. The drying phase is cancelled.

Switching the dishwasher off

Switch the dishwasher off, when the indicator lamp

for the programme cycle end is lit.

1. Turn the programme selector to the "Reset"

position. All indicator lamps goes out.

Be careful if you open the door immediately

after the programme is ﬁnished, since hot

steam may escape.

Cleaning the dishwasher

Clean the outside surfaces of the appliance using a mild

(non-abrasive) household cleaning product. Finish by

removing remaining traces of the product with a damp cloth.

Do not use cleaning products which contain

alcohol (spirits), thinners and similar sub-

stances.

- 10 -