Electrolux ESF 2420 지침서 - 페이지 15

{카테고리_이름} Electrolux ESF 2420에 대한 지침서을 온라인으로 검색하거나 PDF를 다운로드하세요. Electrolux ESF 2420 16 페이지. Dishwasher
Electrolux ESF 2420에 대해서도 마찬가지입니다: 지침서 (20 페이지)

페이지 인쇄

Installation

Water inlet

The dishwasher is equipped with safety features

which are to prevent the water from going back

to the fresh water system. These features are ac-

cording to current water technical safety regulations.

The temperature of the water supply should not exceed 65° C

and the pressure should be between 80-1000 kPa (0,8 - 10 bar).

It is important to have a tap or stopcock, positioned close to

the dishwasher and with easy access. Special mixer taps with

dishwasher connections are available, as well as adaptors

for older mixer taps. Connect the inlet hose to a tap with a

3/4" pipe thread.

The inlet hose must not be joined onto any form of extension

hose. If it is too short, the entire hose must be replaced with

a longer high-pressure hose, specially designed for the

purpose. The end of the hose, which is connected to the

dishwasher can be turned in any direction. Loosen the

retaining nut, turn the hose, then retighten the nut.

Check that the nut and all other connections are

tight before the machine is moved into position.

Use only the inlet hose supplied to the dish-

washer, do not reuse the old inlet hose.

Water drainage

To protect the dishwasher against water damage it is

equipped with a water safety system. In the event of

a fault the drain-pump starts automatically and the

remaining water inside the dishwasher is pumped out.

The water safety system also works when the

dishwasher is switched off. However the dish-

washer must be connected electrically.

Place the discharge hose over the sink as illustrated.

It must not at any point be higher up than 75 cm over the

surface which the dishwasher is standing on. If it runs

higher, operation of the dishwasher might be impaired.

It is also important to ensure that the inside diameter of the

hose is not less than 13 mm at any point. If the discharge

hose is too long, it can easily be cut to the right length.

1. Cut the hose to a suitable length, using a sharp

knife.

2. Fit the elbow supplied onto the end of the hose.

Electrical connection

The dishwasher is supplied with a lead and electrical plug

for connection to a 230 V earthed wall socket, which should

be easily accessible and protected by a 10 A fuse.

Before any work is carried out on the dishwasher,

it must be isolated from the electric mains supply,

for example by removing the plug from the wall

socket.

Permanent electrical installation must be carried

out by an authorised electrician or competent

person.

- 15 -