Electrolux ESF 6162 지침서 - 페이지 5
{카테고리_이름} Electrolux ESF 6162에 대한 지침서을 온라인으로 검색하거나 PDF를 다운로드하세요. Electrolux ESF 6162 20 페이지.
Electrolux ESF 6162에 대해서도 마찬가지입니다: 지침서 (20 페이지)
페이지 인쇄
The sink plug must not be in place when the machine is
draining as this could cause the water to syphon back into the
machine.
If you use a drain hose extension it must be no longer than 2
metres and its internal diameter must be no smaller than the
diameter of the hose provided.
Likewise the internal diameter of the couplings used for
connections to the waste outlet must be no smaller than the
diameter of the hose provided.
Attention!
Our appliances are supplied with a security device to protect
against the return of dirty water back into the machine.
If the spigot of your sink has a "no return valve" incorporated
this can prevent the correct draining of your dishwasher.
We therefore advise you to remove it.
Description of the appliance
1.
Upper basket stop
2.
Water hardness dial
3.
Salt container
4.
Detergent dispenser
5.
Control panel
6.
Rating plate
7.
Rinse aid dispenser
8.
Filters
9.
Lower spray arm
10. Upper spray arm
11. Upper basket
12. Worktop
NOTE:
this dishwasher has an
internal light that turns on and off when
the opening and closing of the
dishwasher's door occurs.
In case that this light has to be
replaced, please contact your local
Electrolux Service Centre.
Electrical connection
Information concerning the electrical connection is given on the
rating plate on the edge of the dishwasher's door.
Before plugging the appliance into the wall socket, make sure
that:
1. The mains voltage and current rating at the site of
installation match the nominal voltage and current rating
given on the rating plate.
2. The meter, fuses, mains power supply and wall socket can
all take the maximum load required. Make sure that the
socket and plug are compatible without having to use any
type of adaptor. If necessary, have the domestic wiring
system socket replaced.
To isolate the dishwasher from mains, remove the mains plug.
Important!
The plug must still be accessible after the appliance
has been installed.
In case that the electrical cable has to be replaced,
please contact your local Electrolux Service Centre.
The appliance should not be connected to the
electrical supply by means of an extension cable.
Safety standards require the appliance to be
earthed.
The manufacturer accepts no liability for failure to
observe the above safety precautions.
IN144
5