Forme HTR-VERTSNGL 설치 지침
{카테고리_이름} Forme HTR-VERTSNGL에 대한 설치 지침을 온라인으로 검색하거나 PDF를 다운로드하세요. Forme HTR-VERTSNGL 2 페이지. Vertical heated bar
페이지 인쇄Vertical Heated Bar Installation Instructions
Items Required For Installation:-
•
Forme Single Vertical Bar - Heated Stainless Steel Towel Rail
•
12Volt Transformer
•
Fixing Kit includes:
o
3 x Countersunk Screws
o
3 x Wall Plugs
o
1 x Threaded Tube
o
1 x Nut
o
1 x Non Wired Mounting Bracket
o
1 x Wired Mounting Bracket
1 x Diamond Drill Bit
o
1 x Allen Key
o
3 x Grub Screws (Supplied inside bar)
o
2 x Small Machine Screws
o
o
1 x Mounting Bracket
o
1 x Mounting Drill Template
Tools Required For Installation:
•
Cross Head Screwdriver
•
Pencil
•
Spirit Level
•
Tape Measure
•
Drill Bits
•
Cordless Drill
•
Electrical Supply
How To Install:
•
Switch off the mains power.
You will be installing the Vertical Rail as part of a high voltage mains electrical circuit. To ensure your
o
safety and to protect the Vertical Rail, switch off the mains power before you start the installation.
•
Install the transformer
The transformer is to be installed in the ceiling or the wall cavity no further than 2m from the rails and
o
needs to be connected to the mains power supply in accordance with current local building
regulations. If mounting in the wall cavity the transformer must be behind an access plate or a
timer/switch to enable access and the transformer must have ventilation.
•
Install two wall brackets
Measure and mark out the bracket positions making sure they are level. Drill a 6mm hole for each of
o
the two wall brackets and an extra hole for the cable at the wiring point and insert suitable wall plugs.
Fix the two mounting brackets in place using a screwdriver and screws.
•
Electrical Connections
Ensure your electrical supply is switched off. Push the cable through the hole in the wall bracket and
o
connect to the transformer previously installed (refer to the wiring diagrams opposite). Please note
multiple rails need to be wired in parallel.
•
Fix the Vertical Heated Towel Rail to the wall
Fit the Vertical Rail to the mounting brackets installed on the wall. You may need assistance to hold
o
the rail in place. Tighten the grub screws on the two wall mount arms using the allen key provided.
•
Fix the hook to the Vertical Rail
Please note that the hook is optional and is not necessary for the unit to operate, however is included
o
with every rail. Slide the hook on the top of the vertical bar (ensuring that the small screw hole is
facing towards the wall) and hold in desired position. Use the small machine screw to fix in position.