Ather Dot 사용자 매뉴얼 매뉴얼 - 페이지 6

{카테고리_이름} Ather Dot에 대한 사용자 매뉴얼 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Ather Dot 18 페이지. Home charging point

Installation pre-checks

Make sure that your home has proper earthing.

If the voltage between Neutral-Earth terminals

of any socket in your home is less than 25V, the

earthing qualifi es to be healthy.

Healthy Earthing

< 25V

Note: Get your local electrician to check the voltage

or DIY using the multimeter in case you want to

check the health of the socket's earth connection.

Ensure that the electric source is close by.

The Ather Dot™ comes with 1 meter of input

cable. The open terminals of the input cable

must be connected to the circuit breaker that is

next to the utility energy meter of your home, as

explained in the "How to install?" section (pg. 11).

Note: Do assess beforehand, just in case you need

a longer wire, as we do not recommend using

extension cords.

You can also use a 6A socket, by connecting the

3 pin plug to the open terminals of the input

cable, incase you do not have access to the

energy meter of your home.

Earth

Neutral

4 things you need

Drill machine with M6 wall drilling attachment and hammer

Multimeter

Screwdriver

Cables and conduit (For wire extension to the meter)

How to install?

Steps to set-up the Ather Dot™

Step 1

Use the stencil to precisely mark all the 4

screws' position on the wall. The arrow mark

on stencil should be pointing upwards for an

accurate marking.

Recommended height: 1.5 m from the ground.

Note - In case of uneven surface or obstacles at the

recommended height, you can mount the

Ather Dot™ at your convenient height. Just that, it

should not be too low for it to get aﬀ ected by water

clogging or splashing.