Electrolux ESF 6720ROW 사용자 설명서 - 페이지 17

{카테고리_이름} Electrolux ESF 6720ROW에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Electrolux ESF 6720ROW 20 페이지. Electrolux911 417 023

페이지 인쇄

1. Troubleshooting

Problem

The appliance does not fill with

water.

The appliance does not drain the

water.

The anti-flood device is on.

After the checks are completed, activate

the appliance. The programme continues

from the point of interruption.

If the problem occurs again, contact the

Service.

If the display shows other alarm codes,

contact the Service.

10.1 If the washing and drying

results are not satisfactory

Whitish streaks or bluish layers on

glasses and dishes

• The released quantity of rinse aid is too

much. Adjust the rinse aid selector to a

lower position.

• The quantity of detergent is too much.

Stains and dry water drops on

glasses and dishes

• The released quantity of rinse aid is not

sufficient. Adjust the rinse aid selector

to a higher position.

• The quality of the detergent can be the

cause.

Dishes are wet

• The programme is without a drying

phase or with a low temperature drying

phase.

• The rinse aid dispenser is empty.

Possible solution

Press Start.

If the delay start is set, cancel the setting or

wait for the end of the countdown.

Make sure that the water tap is open.

Make sure that the pressure of the water sup-

ply is not too low. For this information, con-

tact your local water authority.

Make sure that the water tap is not clogged.

Make sure that the filter in the inlet hose is not

clogged.

Make sure that the inlet hose has no kinks or

bends.

Make sure that the sink spigot is not clogged.

Make sure that the drain hose has no kinks or

bends.

Close the water tap and contact the Service.

• The quality of the rinse aid can be the

cause.

• The quality of the combi detergent tab-

lets can be the cause. Try a different

brand or activate the rinse aid dispens-

er and use rinse aid together with the

combi detergent tablets.

Refer to 'HINTS AND TIPS' for

other possible causes.

10.2 How to activate the rinse

aid dispenser

The activation of the rinse aid dispenser

can occur only with the Multitab option

activated.

1. Press the on/off button to activate the

appliance.

2. Press Reset for a few seconds.

3. Press and hold, at the same time, De-

lay and AutoOpen until the indicators

flash.

4. Press TimeSaver,

•

The indicators

off.

ENGLISH

and

start to

and