Electrolux ESF 8620ROX 사용자 설명서 - 페이지 18

{카테고리_이름} Electrolux ESF 8620ROX에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Electrolux ESF 8620ROX 20 페이지.

페이지 인쇄

www.electrolux.com

Problem and alarm code Possible solution

The programme does not

start.

The appliance does not fill

with water.

The display shows

The appliance does not

drain the water.

The display shows

The anti-flood device is on.

The display shows

Once you have checked the appliance,

deactivate and activate the appliance. If

the problem occurs again, contact an

Authorised Service Centre.

12.1 The washing and drying results are not satisfactory

Problem

There are whitish streaks or

bluish layers on glasses and

dishes.

There are stains and dry wa-

ter drops on glasses and

dishes.

The dishes are wet.

Refer to "Hints and tips" for

other possible causes.

• Make sure that the appliance door is closed.

• Press Start.

• If the delay start is set, cancel the setting or wait for

the end of the countdown.

• The appliance has started the procedure to recharge

the resin inside the water softener. The duration of the

procedure is approximately 5 minutes.

• Make sure that the water tap is open.

• Make sure that the pressure of the water supply is not

too low. For this information, contact your local water

authority.

• Make sure that the water tap is not clogged.

• Make sure that the filter in the inlet hose is not clog-

ged.

• Make sure that the inlet hose has no kinks or bends.

• Make sure that the sink spigot is not clogged.

• Make sure that the drain hose has no kinks or bends.

• Close the water tap and contact an Authorised Service

Centre.

For alarm codes not described in the

table, contact an Authorised Service

Centre.

Possible solution

• The release quantity of rinse aid is too much. Adjust

the rinse aid selector to a lower position.

• The quantity of detergent is too much.

• The released quantity of rinse aid is not sufficient.

Adjust the rinse aid selector to a higher position.

• The quality of the rinse aid can be the cause.

• The programme does not have a drying phase or

has a drying phase with low temperature.

• The rinse aid dispenser is empty.

• The quality of the rinse aid can be the cause.

• The quality of the multi-tablets can be the cause. Try

a different brand or activate the rinse aid dispenser

and use rinse aid and multi-tablets together.