Formech 686 빠른 시작 매뉴얼 - 페이지 6

{카테고리_이름} Formech 686에 대한 빠른 시작 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Formech 686 6 페이지.

Back

This operation will exit the main operation screen and return to the main menu screen.

Auto-level

This operation enables the beam sensor to provide automatic levelling of the sheet level

during heating. Compressed air is applied under the heated sheet when the beam is broken.

This button latches and may be unlatched at any time.

Auto-Vacuum

This function allows the vacuum to be triggered by a limit switch mounted on the cylinder.

When this feature is enabled the vacuum will be turned on automatically when the table is

driven up. The switch position is adjustable.

Settings

This button provides access to the settings screen where the operating parameters may be

adjusted.

Notes:

* You will fine-tune the amount of time after a few pulls. The timer keeps track of from when you

pulled the heater forward to when you pushed back.

** If there are any issues (webbing, thinning, mold not releasing, etc) with your mold refer to the

guide books in the machine manual to evaluate your issues.

Plastics Lab

V1.0 2/8/2018