Formech DT-508 사용자 설명서 - 페이지 3
{카테고리_이름} Formech DT-508에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Formech DT-508 5 페이지. Vacuum forming machine
페이지 인쇄Placing Material in Formech
Using Reducing Window
Before you vacuum form your part measure it to see if you need to use the reducing
window (either half window or quarter window)
o If your part is smaller than 9x10 inches use the quarter reducer, if it is smaller
than 18x10 use the half reducer
o Because the regular size material is 18x20 inches you can cut a full size piece into
four pieces to use in the quarter reducer or in two pieces for the half reducer
o When inserting the reducing window follow the steps below