AND UA-705 사용 설명서 - 페이지 8
{카테고리_이름} AND UA-705에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. AND UA-705 15 페이지.
Applying The Arm Cuff
1. Wrap the cuff around the upper arm, about
1 to 2 cm above the inside of the elbow, as
shown.
Place the cuff directly against the skin, as
clothing may cause a faint pulse and result
in a measurement error.
2. Constriction of the upper arm, caused by
rolling up a shirtsleeve, may prevent
accurate readings.
3. Confirm that the index
proper fit range.
How To Take Proper Measurements
For the most accurate blood pressure measurement:
Sit comfortably on a chair. Rest your arm on the table. Do not cross your legs.
Keep your feet on the floor and straighten your back.
Relax for about five to ten minutes before measurement.
Place the center of the cuff at the same height as your heart.
Remain still and keep quiet during measurement.
Do not measure immediately after physical exercise or a bath. Rest for twenty or
thirty minutes before taking the measurement.
Try to measure your blood pressure at the same time every day.
Measurement (Operation)
During measurement, it is normal for the cuff to feel very tight.
Select a measurement mode (operation of the device).
Normal measurement with storing data :
Recalling data :
............................................................
Clearing data :
......................................................................................................
After Measurement
After the measurement is completed, remove the cuff and record your data, then
press the
START
Note: The device is an automatic power shut-off function, which turns the power off
approximately one minute after measurement.
Allow at least three minutes between measurements on the same person.
Using The Monitor
points within the
.....................................................
Press and hold the
button to turn off the power.
English 7
Do not roll up shirtsleeve tightly
Cuff
1 to 2 cm
Artery position mark
Secure
fastener firmly
Index
and Proper fit range
Press the
button to recall data.
START
Remove the battery and re-install it.
the
fabric
Air hose
button.
START