Airstream 1000 Series 빠른 참조 매뉴얼 - 페이지 15
{카테고리_이름} Airstream 1000 Series에 대한 빠른 참조 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Airstream 1000 Series 16 페이지.
페이지 인쇄Please read the manual for
your dryer model, before using
the quick reference.
QUICK START UP PROCEDURE
ELECTRONIC MONITORING
CONTROL SYSTEM-QUICK REFERENCE
IMPORTANT! To activate the controller after turning on the control power,
press the RESET button.
Setting the DRY, COOL, UNLOAD & OUT OF GRAIN timers:
•
Press the DRY, COOL, UNLOAD or OUT OF GRAIN button.
•
Press the MODIFY button.
•
Press the INCREASE or DECREASE button to get desired setting.
•
Press the ENTER button when desired setting is reached.
Setting the LOAD & UNLOAD DELAYS:
•
Press the LOAD or UNLOAD button.
•
Press the MODIFY button.
•
Press the INCREASE or DECREASE button to get desired setting.
•
Press the ENTER button when desired setting is reached.
Pressing the INCREASE and DECREASE buttons simultaneously will ac-
cess the following programming features:
•
SAFETY CIRCUIT SHUTDOWN LOG
•
DRYER MODEL NUMBER
•
FAN DELAY
•
BPH FACTOR
•
METERING ROLL MONITOR DISABLING FEATURE
•
AIR SWITCH DISABLING FEATURE
These features are accessed sequentially as listed above. Press the IN-
CREASE or DECREASE buttons to change a setting. Press the ENTER
button to move from feature to feature.
Pressing and holding the RESET button for five (5) seconds will access the
following programming features:
•
CALENDAR YEAR SETTING
•
CALENDAR MONTH SETTING
•
CALENDAR DAY SETTING
•
CLOCK HOUR SETTING
•
CLOCK MINUTE SETTING
•
BUSHEL COUNTER RESET
•
BATCH COUNTER RESET
These features are accessed sequentially as listed above. Press the IN-
CREASE or DECREASE buttons to change a setting. Press the ENTER
button to move from feature to feature.
Changing the Marquee on the LCD display:
•
Press and hold the MODIFY button while turning on the control power.
•
To change a character press the INCREASE or DECREASE button.
•
To move the cursor to right press the UNLOAD button.
•
To move the cursor to the left press the DRY button.
•
To delete a character press the COOL button.
•
Press ENTER when the desired marquee is displayed.
15