AND HL-WP Series 사용 설명서 - 페이지 7

{카테고리_이름} AND HL-WP Series에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. AND HL-WP Series 10 페이지.

Gravity compensation

If you have calibration weights at the capacity of the scale, you can calibrate

the scale with the weights instead of compensating for acceleration due to

gravity.

The scale was calibrated at 9.798 m/sec

to gravity at your location is not same, compensate the scale by adjusting the

acceleration due to gravity. (Refer "The Value of Gravity at Various Locations"

and "World Map" and find your location value.)

1. Enter calibration mode.

Press the [ON/OFF] key to turn the power off. While pressing both the

[RE-ZERO] key and the [UNITS] key, press the [ON/OFF] key. Cal will

be displayed.

2. Select a digit to be changed.

Press the [UNITS] key. The previously set value, for example 979, 8 , will

be displayed. A digit after the comma "," will be changed by pressing the

[RE-ZERO] key. Press the [UNITS] key to move the comma "," and select

a digit to be changed.

3. Set the new value

Change the value of the gravity acceleration using the [RE-ZERO] and

[UNITS] keys.

4. Save the value in memory.

Press and hold the [UNITS] key until end is displayed. The scale will

automatically return to the weighing mode.

, at the factory. If the acceleration due