formlabs Form Wash 빠른 시작 매뉴얼 - 페이지 6

{카테고리_이름} formlabs Form Wash에 대한 빠른 시작 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. formlabs Form Wash 13 페이지.

USING FORM WASH

Use the display and knob to raise the platform and basket mounts. For

convenience, install the build platform directly in Form Wash to clean

parts before removal. Align the top lip of the build platform with the

arms of Form Wash's platform mount, and fully insert to touch the back.

TIP

For a complete wash, ensure that IPA is filled between the minimum

and maximum fill lines.

Parts can also be washed in the

basket, either as an alternative or in addition to the platform mount.

Place parts directly in the basket after removing them from the build

platform using the removal tool, scraper, or flush cutters. The basket

comes installed in Form Wash. Without a build platform installed, the

basket can be removed by lifting vertically from the basket mount.

NOTE

Parts must be washed on the build platform and/or in the basket.

Washing loose parts directly in the wash bucket will damage printed

parts, create noise, and may interfere with the agitation of IPA.

CAUTION: Wear gloves when handling parts

and surfaces with IPA or uncured resin.