ATHLYT ATH-1900HA 매뉴얼 - 페이지 9

{카테고리_이름} ATHLYT ATH-1900HA에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. ATHLYT ATH-1900HA 11 페이지. Unisex’s hydraulic rower

SPECIFICATIONS:

TIME ---------------------------------------------------- 00:00 - 99:59 MIN:SEC

DISTANCE--------------------------------------------0.00 - 99.99 KM OR ML

COUNT -------------------------------------------------- 0 - 9999 TIMES

CALORIES ------------------------------------------------ 0 - 9999 KCAL

TOTAL COUNT(option) ----------------------------------- 0 - 9999 TIMES

KEY FUNCTION:

MODE/SELECT: To select the function you want. Hold the key for 4 seconds to have all

function values reset (total reset).

SET(option): To input the target value by the key.

RESET/CLEAR (option): To let the value reset.

OPERATION PROCEDURES:

AUTO ON/OFF .The monitor will be automatically shut off if there is no signal coming in for 4

minutes. The monitor will be auto-powered when start exercise or press the

key.

FUNCTION:

<1>.TIME(TMR)

Auto-memorize the workout time while exercising.

<2>.COUNT(CNT)

Accumulate the steps while exercising.

<3>.CALORIES(CAL)

Auto-memorize calories amount consumed while exercising.

<4>.DISTANCE(DST)

Accumulate the distances while exercising.

<5>.TOTAL COUNT(TOTAL) (option).

Display the total counts while exercising.

When the signal input, it start the count up on the original data.

The TOTAL COUNT can't be reset(by RESET key)except you replace battery once.

<6>.SCAN

Automatically scan through each function

between①TIME②COUNT③DISTANCE④T-COUNT(OPTION)⑤CALORIES

BATTERY

If there is a possibility to see an improper display on the monitor, please replace

the batteries to have a good result. This monitor uses two "AA" batteries. You can replace the

batteries at the same time.