Dreame Bot L10 Pro 사용자 설명서 - 페이지 10

{카테고리_이름} Dreame Bot L10 Pro에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Dreame Bot L10 Pro 14 페이지. Robot vacuum and mop

Routine Maintenance

Clean the Dust Bin and Filter

1. Open the robot cover, then press the dust bin clip to remove the

dust bin.

2. Open the dust bin cover as indicated by the diagram.

3. Remove the filter and tap its basket gently.

Note: Do not attempt to clean the filter with a brush or finger.

4. Rinse the dust bin and filter with water until they are clean.

Thoroughly dry the filter before re-installing.

Note:

• Only clean water should be used to clean the filter. Do not use detergent.

• Before using, keep it in a well-ventilated or cool place.

Routine Maintenance

Clean the Mopping Module

1. Press the two release clips on the side of water tank, remove the

mopping module and pull the mop pad off the mopping module.

2. Pour out the water in the tank. Clean with water only and leave to

air dry before re-installing.

Note: Do not expose the tank to the sun directly.

3. Clean the mop pad with water only and leave to air dry before re-

installing.

Note:

• Remove the pad from the mopping module before cleaning it, and

make sure dirty water does not flow back into the water outlet to avoid

clogging.

• For optimal performance, it is recommended to replace the mop pad

every 3 to 6 months.

4. If slow water flow occurs, or the volume is not well-distributed,

please clean the air hole in the cover of the water tank.