ATI Audio DA1000 운영 및 유지보수 매뉴얼 - 페이지 3
{카테고리_이름} ATI Audio DA1000에 대한 운영 및 유지보수 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. ATI Audio DA1000 7 페이지. 1x8 analog audio distribution amplifier/ microamp series
페이지 인쇄
SIGNAL PRESENT INDICATOR
The second half of Al monitors the voltage at the output of the input buffer IC. The green
Signal Present LED on the front panel will light for audio inputs over -30dBm. The LED
will normally flicker with applied program material to tell you that all is well. (Happiness
is a green LED.)
OUTPUTS
Audio from the input buffer is AC coupled to the front panel level adjust potentiometer.
This control adjusts the level of all outputs. If you are afflicted with lurking knob
twiddlers, the knob can be removed leaving a somewhat less inviting screwdriver
adjustment. If removing the knob doesn't cure the problem, put your DA out of reach by
sticking it to the ceiling using the supplied suction cup feet.
The pot output is applied to the non-inverting input of the HI (in-phase) output stage
driver IC (A2-1). The IC supplies the first 10 mA of output current directly and then the
complementary Class B output booster transistors (Q1 and Q2) take over. The unique,
wide bandwidth, high slew rate circuit design provides effective class AB operation with
minimal crossover distortion from a power output stage operating true Class B with zero
quiescent power dissipation.
The HI output bus is applied to the inverting input of A2-2 in a unity gain, phase
inverting configuration and boosted by Q3 and Q4 to form the LO output bus.
The HI and LO output buses are split into nine individual outputs (eight rear and one
front panel jack) through 150 ohm build-out resistances. All outputs will tolerate short
circuits across the output or to ground without damage. Up to two outputs can be shorted
with no significant reduction in headroom. Needless to say, this is NOT the
recommended mode of operation. Do not drive single-ended (one side grounded) loads
from both HI and LO outputs together. Drive single ended loads from either the HI or LO
outputs to ground. Up to 18 single-ended 600-ohm output loads may be simultaneously
driven.
The build-out resistors are split and heavily bypassed to prevent RF pickup on the output
lines from affecting operation of the DA. These bypasses will place a very heavy load on
the outputs under sustained sine wave operation above 20kHz and such operation may
over-dissipate the 47 ohm build-out resistors—don't do it!
OUTPUT CLIPPING INDICATOR
The differential input voltage of HI output driver IC (A2-1) is monitored by A3. The
differential voltage is under a few millivolts under linear operation; however, if the
output is driven to clipping, the differential voltage rapidly increases and is amplified to
ATI Audio Inc.
■ Tel: 856-626-3480
■
Fax: 856-504-0220
■
www.
audio.com