Dreame VPV11A 사용자 설명서 - 페이지 9
{카테고리_이름} Dreame VPV11A에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Dreame VPV11A 10 페이지. Cordless stick vacuum
페이지 인쇄
Installing the Dust Cup, Pre-
EN
Filter, and Cyclone Assembly
• Install the cyclone assembly and pre-
filter into the dust cup.
Fig. E-5
• Slightly tilt the dust cup so the slot aligns
with the clip on the vacuum. Then gently
push the dust cup until it clicks into
place.
Fig. E-6
Cleaning the Filter
It is recommended to clean the filter once
every 4 to 6 months.
• Remove the dust cup as shown in the
figure.
Fig. E-7
• Remove the filter from the vacuum by
pulling it down in the direction shown in
the figure.
Fig. E-8
• Rinse the filter with rotating it 360°.
Lightly tap the filter several times to
remove any debris caught in it.
Fig. E-9
Note:
1. Only use clean water to wash the filter.
Do not use detergent.
2. Do not attempt to clean the filter with
a brush or finger.
• Allow the filter to air dry for 24 hours.
Fig. E-10
Installing the Filter
• Insert the filter into the vacuum.
Fig. E-11
• Reinstall the dust cup.
Fig. E-12
Replacing the Battery Pack
The vacuum contains a removable
rechargeable lithium-ion battery pack
which has a limited number of recharge
cycles. After extended use, the battery
pack may no longer hold a charge. If this
happens, it means the battery pack has
reached the end of its life cycle and needs
to be replaced.
14
• Press down the battery pack release
button and slide the battery pack to the
right, as illustrated, to remove it.
• Install the new battery pack.
Fig. E-13
Cleaning the Multi-Surface
Brush
• Turn the lock counterclockwise until it
stops, then remove the brush roller from
the brush.
Fig. E-14
• Use scissors to cut off hairs and fibers
tangled on the brush roller. Wipe the
dust from the notch and brush cover
with a dry cloth or paper towel.
Fig. E-15
• When it is dirty, rinse the brush roller with
clean water until it is clean.
Fig. E-16
• Stand the brush roller upright for at least
24 hours until it is fully dry.
Fig. E-17
Cleaning the Motorized
Mini-Brush
• Use a coin as illustrated to rotate the
lock counterclockwise until you hear a
click.
Fig. E-18
• After unlocking the motorized mini-
brush, remove the brush roller, then
rinse and clean it.
Fig. E-19
• Stand the brush roller upright in a well-
ventilated area for at least 24 hours until it
is fully dry.
Fig. E-20
• Once the brush roller is dry, reinstall it
by following the disassembly steps in
reverse.
Fig. E-21
Specifications
Vacuum Cleaner
Model
VPV11A
Rated Power
370 W
Rated Voltage
25.2 V
Charging Time
approximately 4 hours
Multi-Surface Brush
Model
VMR1
Rated Power
40 W
Rated Voltage
25.2 V
Motorized Mini-Brush
Model
VPA1
Rated Power
20 W
Rated Voltage
25.2 V
Charger
Model
ZD012M300065EU
100-240 V
50/60 Hz
Input
0.5 A
Output
30 V
0.65 A
Average Active
85.36%
Efficiency
Efficiency at Low
75.35%
Load (10%)
No-load Power
0.1 W
Consumption
Rechargeable Lithium-Ion Battery Pack
Model
V2316-7S1P-SCA
Nominal Voltage
25.2 V
Nominal Capacity
2500 mAh
Rated Capacity
2300 mAh
Energy
57.96 Wh
EN
15