ATI Audio DA2008-1 광고 운영 관리 매뉴얼 - 페이지 4

{카테고리_이름} ATI Audio DA2008-1에 대한 광고 운영 관리 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. ATI Audio DA2008-1 7 페이지. Dual 1x4 distribution amplifier

HEADPHONE OUTPUT

The front panel headphone jack is a convenient metering point, an auxiliary

output or headphone output. The jack is wired to drive stereo headphones with

channel A to the tip and channel B to the ring. The sleeve connection is wired to

ground. The jack is isolated by 470 ohm build-out resistors.

Your DA2008-1 power supply incorporates a couple of unique regulating devices

called zener diodes. In contrast to most fancy IC regulators, these devices will

live through most line transients and simultaneously protect your expensive

circuitry. As further insurance, a varistor suppressor is placed across the power

transformer secondary.

MOUNTING

Your DA2008-1 may be desk mounted on its non-slip suction cup feet, or

securely rack mounted with our optional 21075-501 Rack Mount Shelf. Since the

DA2001-8 is 1/2 rack width, the 21075-501 supports up to two units side by side.

A 1/2 rack Filler Shelf, ATI Part Number 21098-501, is available if you are rack

mounting only one unit.

WIRING

The DA2008-1 line cord contains a three-wire grounded plug. The third wire

ground can cause a ground loop with your facility ground. If you are sure your

facility ground will provide adequate protection to personnel in case of an AC line

short to chassis, a 3-to-2 AC adapter can be used to isolate the power line

ground. We recommend that the adapter be removed and the power line ground

reconnected prior to any service work requiring removal of the facility ground

from the DA chassis.

The four inch silver bearing copper strap, which you are, of course, using for your

main facility ground is not going to fit around the #6 chassis ground screw on the

DA2008 rear panel. Run the strap to within a few inches of the chassis and jump

to the chassis ground with shield braid.

Audio inputs and outputs should be connected using the rear panel labels as a

guide. Hi outputs are all in phase with each other and in phase with the Hi inputs.

Fanning strips are provided so that our ears won't be burning in the middle of the

night while you are trying to wrap wires around those tiny barrier strip screws.

ATI Audio Inc.

■ Tel: 856-626-3480

Fax: 856-504-0220

www.

audio.com

■