Forms+Surfaces CROSS TABLE 설치 지침 - 페이지 2

{카테고리_이름} Forms+Surfaces CROSS TABLE에 대한 설치 지침을 온라인으로 검색하거나 PDF를 다운로드하세요. Forms+Surfaces CROSS TABLE 2 페이지.

페이지 인쇄
Forms+Surfaces CROSS TABLE 설치 지침
CROSS TABLE
STEP BY STEP
FOR ALL SURFACE MOUNTED CROSS TABLES
b
Insert & set anchors
• Use compressed air and steel wire brush
to clean each anchor hole.
• Insert 3/8"-16 x 1-1/2" anchor (b) into
each anchor hole and use hammer to tap
anchor tops flush with ground level.
• Use 1/4" punch and hammer to set
anchors by driving down the center of
each anchor until it stops.
T 800.451.0410 | www.forms-surfaces.com
© 2012 Forms+Surfaces® | All dimensions are nominal. Specifications and pricing subject to change without notice. For the most current version of this document, please refer to our website at www.forms-surfaces.com.
Position & attach table
• Position table so that mounting holes line
up with anchors.
• Slide 3/8" stainless steel lock washer (d),
then 3/8" stainless steel flat washer (e)
and 3/8" nylon flat washer (f) onto each
3/8"-16 x 1" tamper-resistant button
head cap screw (c).
• Insert screws into mounting holes in table
and thread into anchors using provided
7/32" hex bit for tamper-resistant
screws.
SURFACE MOUNT INSTALLATION INSTRUCTIONS
c
d
e
f
Tighten screws
• Tighten screws until snug.
page 2 of 2 | Rev. 12-18-12