Carmanah 502 소유자 매뉴얼 - 페이지 7

{카테고리_이름} Carmanah 502에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Carmanah 502 16 페이지. Solar led light

페이지 인쇄

You can program multiple settings within one session by pressing any button within the 1 minute window

that the infrared sensor is on. Pressing the Start button causes the infrared sensor to remain on for an

additional minute from the time the button was pressed. If the button is not pressed within the 1 minute

window you must re-transition the light and re-enter the security code to complete or continue

programming the light.

When programming a Model 502 light, the key sequence on the programmer and the responding flash

sequence from the light is always in the format shown in Figure 3-1 regardless of the settings being

configured.

Figure 3-1: Programming Sequence

Press

Single

Press the

Start

flash from

first

the light

number of

the code

Do not press the buttons on the programmer too fast and do not proceed until you see a

flash from the light.

One of the flash patterns described in Table 3-2: Programming Completion displays after the

programming sequence is complete. The flash pattern indicates whether or not the programming was

successful.

Table 3-2: Programming Completion

Programming Result

Successful

Unsuccessful

Figure 3-2: Successful Programming Sequence

Figure 3-3: Unsuccessful Programming Sequence

An unsuccessful programming sequence for the Model 502 light occurs for one of the following reasons:

the light does not recognize the sequence, or

the light has not received the correct security code

If the programming sequence is unsuccessful, re-enter the key sequence for the required code. If the

programming sequence is still unsuccessful, re-enter the security code.

Single

Press the

flash from

second

the light

number of

the code

Flash Pattern

Description

Three quick consecutive flashes indicate that the code has been

accepted. You will see this flash after every successful entry.

Two longer flashes indicate that the code has not been accepted.

Restart the programming sequence.

Single

Press the

Single

flash from

third

flash from

the light

number of

the light

the code

Owner's Manual | Model 502

Press

Single

Enter

flash from

the light

Revised: August 2008