AND-Tech AVR Prog USB v2 매뉴얼 책자 - 페이지 3

{카테고리_이름} AND-Tech AVR Prog USB v2에 대한 매뉴얼 책자을 온라인으로 검색하거나 PDF를 다운로드하세요. AND-Tech AVR Prog USB v2 17 페이지. Programming device

1. Installation

The programmer is connected to a computer using a USB A-B mini connection (most frequently used

with digital cameras ). It is advised to use a cord not longer than 1.8m.

A connection with the programmed set is conducted by a IDC-10 data tape. A connection with a

programmed device performed by IDC-10 connectors on both ends. Programmer uses a set of pins

Atmela standard compatible – to use it, take a one-one –one, non interlaced cable.

ATTENTION !!

If, after a successful installation, a programmer is detected by Windows and lits a green LED, but

does not operate, connect the programmer to a PC/laptop excluding HUBs and docking station. In some

specific situations, programmer's functions may be interrupted by these devices.

To install a programmer as a HID device, place a jumper presented at the picture as JP3. Afterwards

connect the programmer with a computer. The programmer will install its self automatically. It will take

a few seconds.

WARNING! Programmer installed as HID is commanded by a avrdude software.