ATI Audio WC106 운영 및 유지보수 매뉴얼 - 페이지 12

{카테고리_이름} ATI Audio WC106에 대한 운영 및 유지보수 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. ATI Audio WC106 14 페이지. Quad 1x4 aes/ebu distribution amplifier and 1x6 clock distribution amplifier

페이지 인쇄

INSTALLATION

LOCATION

The DDA is readily installed into a 2 RU, 19" rack. The DDA is only to be installed in an inside

location where it is protected from inclement weather. Operate the DDA in temperature range of +5

to +40°C (105°F), with relative humidity ranging from 5 to 85%.

POWER

Connector for socket fused IEC 320/C13. Power cord is supplied. The DDA has a rear panel On

Off power switch.

POWER INPUT SPECIFICATIONS:

Voltage .......................................................................................85 ~ 264Vac

Frequency .....................................................................................47 to 63Hz

This equipment is connected to earth through the center conductor of the AC mains cable. Proper

grounding protects user/operators from electric shock, and it must be maintained whenever the unit

is connected to AC.

WIRING

XLR inputs for external clock sources require special controlled impedance, 110 ohm, low loss, foil

shielded, twisted pair cables. Standard audio cable is not recommended. Belden and most other

cable manufacturers offer special digital audio cabling for this application. BNC connectors use 75-

ohm coax (RG59). Select a cable for losses less than 20dB at 12MHz (for data rates up to 96 k

samples) at the maximum distance you require. Keep cable length as short as possible

DDA-‐416/WC106 M anual