Forms+Surfaces AXIS RECEPTACLE 첨부 파일 지침
{카테고리_이름} Forms+Surfaces AXIS RECEPTACLE에 대한 첨부 파일 지침을 온라인으로 검색하거나 PDF를 다운로드하세요. Forms+Surfaces AXIS RECEPTACLE 2 페이지.
페이지 인쇄AXIS
RECEPTACLE
TM
MATERIALS INCLUDED
b
a
STEP BY STEP
TO ATTACH TWO AXIS RECEPTACLES
Insert top attachment plate
• Each Axis Receptacle comes with one
attachment plate and four screws. To
attach two receptacles you will need two
attachment plates and eight screws.
• Insert top attachment plate (b) into
slot along the straight flat end of the
receptacle, below the lid.
• Align holes in top attachment plate with
holes in top receptacle frame.
T 800.451.0410 | www.forms-surfaces.com
© 2015 Forms+Surfaces® | All dimensions are nominal. Specifications and pricing subject to change without notice. For the most current version of this document, please refer to our website at www.forms-surfaces.com.
TOOLS NEEDED
philips head
screwdriver
Attach top attachment plate
• Insert 1/4"-20 x 1/2" Phillips bit pan
head screws (a) through receptacle
frame and top attachment plate to secure
top attachment plate to receptacle.
• Use Philips head screwdriver to tighten
screws until snug.
ATTACHMENT INSTRUCTIONS
Insert bottom attachment plate
• Insert bottom attachment plate (b) into
slot along the straight flat end of the
receptacle, below the body and above
the base.
• Align holes in bottom attachment plate
with holes in bottom receptacle frame.
page 1 of 2 | 09-17-15