FORMTEK Lockformer TDC-Notcher 운영자 매뉴얼 - 페이지 2

{카테고리_이름} FORMTEK Lockformer TDC-Notcher에 대한 운영자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. FORMTEK Lockformer TDC-Notcher 15 페이지.

THIS EQUIPMENT IS DESIGNED TO BE OPERATED WITH ALL

COVERS SECURED IN PLACE. OPERATION WITHOUT THESE

SAFEGUARDS MAY RESULT IN CONDITIONS WHICH ARE

HAZARDOUS TO THE OPERATOR AND OBSERVERS.

SAFETY GUIDELINES

Before operating the machine, study and follow the safety precautions in this

section. These precautions are intended to prevent injury to you and your fellow

workers. They cannot, however, cover all possible situations. Therefore,

EXERCISE EXTREME CAUTION and use COMMON SENSE before performing any

procedure or operation.

Safety Precautions BEFORE Starting The Machine(s)

Only one person should control the machine(s). Never allow anyone to operate the controls

while you are operating or working on this equipment. In addition to disconnecting power

always use lock outs and tagouts to prevent accidental start-up when performing

maintenance procedures. Keep your hands away from internal workings of the machinery

when starting, running or stopping. Keep your work area clean. Remove all scrap, oil spills,

rags, tools and other loose items that could cause you to slip, trip and fall. When cleaning the

machine or any of its components, do not use toxic or flammable substances. Do not perform

any cleaning while the equipment is running. Never override or disable any safety switch or

safety interlock. If so equipped, make sure that hydraulic and pneumatic pressures are at

specified levels before operating this equipment.

Do not operate the Hydraulic Notcher unless all covers and guards are in place.

Be sure that this Instruction Manual is kept near the machine so the operator can refer to it

when necessary. Keep this equipment properly maintained. Always turn off power to the

machine(s) at the main disconnect before performing any maintenance or adjustments so

accidental start-up or electrocution cannot occur.

Safety Precautions WHILE Operating The Machine(s)

Never leave the work area while the equipment is in operation. Never leave the machine

unattended while it is under power or in operation. Always be alert while operating

machinery. Be alert for loose, worn or broken parts. Do not attempt to operate any machinery

with such parts present or if the machinery is making unusual noises or actions. Avoid skin

contact, prolonged breathing, or eye exposure to any stock lubrication fluid being

used. Be aware of the locations of the Power Off or Emergency Stop button in case of an

emergency.

Be sure all guards and covers are in place.

Continually observe the rollforming process and related equipment. If any unusual condition

develops, immediately stop and inspect the machine. Protect yourself ! Wear safety glasses.

Do not wear loose clothing, neckties, or jewelry. If long sleeves must be worn, avoid loose

cuffs and buttons. Tie back and contain long hair. Never adjust any roll feature or perform

work near the rolls, gears or power take off while they are running.

VER. TDC-Notcher -CE 03-2006

WARNING