FORMTEK Lockformer TDC-Notcher 운영자 매뉴얼 - 페이지 8

{카테고리_이름} FORMTEK Lockformer TDC-Notcher에 대한 운영자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. FORMTEK Lockformer TDC-Notcher 15 페이지.

MAINTENANCE

∆

DISCONNECT POWER BEFORE ATTEMPTING TO MAKE ANY ADJUSTMENTS

ON THE MACHINE.

Install power lock outs to prevent accidental start-up while working on the machine!

For proper maintenance of the hydraulic system, the oil should be kept clean and free of dirt or

other foreign matter. The system should be changed after approximately one year's operation.

This is accomplished by removing drain plug at bottom of reservoir. Replace and fill with clean

filtered oil. A ruler inserted to bottom of reservoir will indicate 7" when proper oil level is reached.

Volume - 10-12 US Gallons, (40-50 liters). Fill to middle of level site on the back of

machine.

DIE CARE AND MAINTENANCE: Punch and dies are manufactured of high carbon high chrome

tool steel for maximum cutting service. When die cutting surfaces become worn it will be

necessary to resharpen.

NOTE: When punch and dies are to be sharpened in the field, grind flat top surface of die

and lower cutting surface of punch. You will note punch has rake angle. This rake

angle must be maintained.

A LIGHT OIL SHOULD BE APPLIED OCCASIONALLY TO CUTTING SURFACE OF PUNCH

AND DIE TO PROLONG DIE LIFE.

NOTE: A slight clearance, not to exceed 0.003"inch( 0.7mm), should be set betwee punch

and die on SLOT-NOTCH by placing a 0.003"inch (0.7mm) to 0.0025" (6.5mm) spacer shim

on both sides of cutting edge of dies.

. For CORNER NOTCH punch and dies, the clearance should be 0.005" (1.3mm).

Setting the clearances is accomplished by adjusting the gibs in the back of the notcher

head.

OIL PRESSURE

During the operation of the machine while the foot switch is depressed and the notchers

have stopped in the down position,the oil pressure should attain a maximum pressure of

1700-1800PSI (12BAR)

VER. TDC-Notcher -CE 03-2006

OIL: The oil used in the reservoir is a

commercial hydraulic

N46 or N68

oil.

RANDO AW HYDR-46 HYDRAULIC OIL

(TEXACO),AW-68 HYDRAULIC OIL (AMACO)

DTE #26 MOBILE