Carmanah E Series 설치 매뉴얼 - 페이지 10
{카테고리_이름} Carmanah E Series에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Carmanah E Series 20 페이지. Rrfb mast arm kit
Carmanah E Series에 대해서도 마찬가지입니다: 빠른 시작 매뉴얼 (20 페이지), 설치 매뉴얼 (16 페이지), 에너지 관리 시스템 교체 매뉴얼 (12 페이지), 사용자 설명서 (18 페이지), 교체 매뉴얼 (9 페이지), 설치 매뉴얼 (18 페이지)
• Obtain 3" of red and 3" of black wire supplied with the kit.
• Strip ends of both wires 0.35".
• Use small flat bladed screwdriver to depress each terminal button and insert the wire into the terminal.
7
• Install one end of the red wire into the left BAT+ terminal.
• Install one end of the black wire into the right BAT− terminal.
• Insert the other end of each wire into two of the 5-position splice terminals.
• Route the two red battery harness wires into the
splice terminal with the red wire from BAT+.
8
• Route the two black battery harness wires into the
splice terminal with the black wire from BAT−.
Carmanah Technologies Corp. | 250 Bay St, Victoria, BC V9A 3K5, Canada | 1.250.380.0052 | [email protected] | carmanah.com
Install Battery Jumper Wires and Splice Terminals
Make sure all wire strands go into the terminal hole.
APPLIED INFORMATION (AI) INTEGRATION KIT INSTALL GUIDE
Red
wires
E/F Series
Black
wires
Page 10