ATI DIGITAL AUDIO DDA416-XLR 사용자 설명서 - 페이지 8

{카테고리_이름} ATI DIGITAL AUDIO DDA416-XLR에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. ATI DIGITAL AUDIO DDA416-XLR 9 페이지. Series 3 ultra-low jitter 192 khz quad 1x4 aes/ebu distribution amplifier

페이지 인쇄

INSTALLATION

LOCATION

To avoid addition of jitter (timing variations) to the output clock signals, which could cause noise and distortion

or loss of synchronization in the recovered audio, avoid locating the DDA in close proximity to a high energy,

high frequency switching type power supply or a power amplifier that utilizes a switching supply. If possible, do

not power both devices from the same AC power line.

POWER

If it is necessary to convert a unit wired for 115VAC to 230VAC operation, unplug the unit from the power

source, remove the cover mounting screws and locate the jumpers next to the power transformer. Clip the

jumpers 1-2 and 3-4 (don't unsolder), jumper from 2-3 carefully soldering together the free ends of 2-3

previously clipped. This procedure is recommended to avoid soldering damage to the multi-layer PC board.

WIRING

XLR inputs require special controlled impedance, 110 ohm, low loss, foil shielded, twisted pair cables. Standard

audio cable is not recommended except for runs of only a few feet. Belden and most other cable manufacturers

offer special digital audio cabling for this application. Keep cable length as short as possible.

DDA416-XLR TECHNICAL SPECIFICATIONS

INPUTS

CONNECTORS

SENSITIVITY

IMPEDANCE

SAMPLE RATES

OUTPUTS

CONNECTORS

LEVEL

IMPEDANCE

SAMPLE RATES

JITTER

PROPAGATION DELAY

INDICATORS

INPUT FAULT LEDs

POWER

SIZE

WEIGHT

WARRANTY

4 XLR female

XLR 1.200mVp-p minimum

110Ω +/- 20%, transformer isolated, balanced and floating

32kHz to 192kHz, independent for each input

16 XLR male

110 Ohm

32kHz to 192kHz

<800 picoseconds peak to peak

<250 nanoseconds

Note: All parameters are validated using Standford Research SR1 –

200 kHz dual-domain audio analyzer

AES 1, AES 2, AES 3 & AES 4

Indicated power to all circuits

Internal Supply, 115/230VAC ±10%, 50/60Hz ±4%, 10VA, IEC320 3

pin connector

2 RU Package, 19" (48.3cm) W x 3.5" (8.9cm) H x 8.5" (21.6cm) D

9 lbs. (4.1kg) net; 10 lbs. (4.5kg) shipping weight

Limited, One Year Warranty

DDA416-XLR Manual