Formula RX 운영 매뉴얼 - 페이지 8

{카테고리_이름} Formula RX에 대한 운영 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Formula RX 20 페이지.

TWO PIECE BRAKE DISC WITH CENTER LOCK ROTOR

Place the hole of the disc 1 in the splined hub 2 pushing it

fully into place.

Place it with the markings facing the operator.

Fully tighten the ring nut 3 using the special wrench speci-

fied below.

Tighten the ring nut to 40 Nm

In the split disc, check the play in the mating point between

the brake disc rotor's arms and the seats inside the disc on

a regular basis

Force the disc in one direction and insert graduated rods of

a thickness gauge in the empty space on the opposite side.

FORMULA SRL considers a play that is the sum of 0.20 mm

as shown in the figure as acceptable.

Replace the brake disc if this value is not present.

MONOLITHIC BRAKE DISC WITH CENTER LOCK

ADAPTER

Place the hole of the disc 1 in the splined hub 2 pushing it

fully into place.

Place it with the markings facing the operator.

Fully tighten the ring nut 3 using the special wrench.

Tighten the ring nut to 40 Nm

If the disc needs to be replaced, hold the adapter in place

and tighten the six screws crosscrossing using a torque set-

ting of 4,5 Nm

5%.

Always use original screws with Loctite®.

5%.