CommScope FOSC-450-BS 설치 지침 - 페이지 11

{카테고리_이름} CommScope FOSC-450-BS에 대한 설치 지침을 온라인으로 검색하거나 PDF를 다운로드하세요. CommScope FOSC-450-BS 16 페이지. Fiber optic splice closure

Central core

6.1.4

First to the basket (see 5.1.11).

6.1.5

From the basket to the trays with the transportation tube. Routing

always from one side to the other side, see picture.

6.2

Fiber routing on the tray

6.2.1

Splicing

For heat shrinkable splice protectors:

•

slide the heat-shrinkable splice protector over one fiber.

•

fuse the fibers according to local recommendations and procedures.

•

after the fusion splice is made, install the heat shrinkable splice

protection (e.g. smouv) with appropriate heating source.

•

allow the splice protection to cool down to ambient temperature.

For ANT splice protectors:

•

fuse the fibers according to local recommendations and procedures.

•

after the fusion splice is made, install the ANT splice protector with

appropriate tool.

6.2.2

Storage

After each splice is made, the splice should be stored in the splice

holder. Do not deform the splice during insertion. The fiber slack should

be coiled into the tray. Follow the routing as shown.

6.2.3

If a tray for up to 16 heat shrinkable fusion splice protectors

is used

• The tray organizer has 6 locations to store splice protectors.

Each location can hold maximum 4 fusion splice protectors of type

smouv-1120-02 (length 45 mm, installed outer diameter is 2,4 mm)

or equivalent.

• After each splice is made, the splice should be stored as

indicated on the drawing. First protector in position 1, the second

in position 2. Continue for other fibers. Fiber nr 5 will be in position

1 of next location.

• If splice protectors are stored on the side with the 4 locations,

the fibers from the locations on the outside are first guided through

the passage between the locations and then coiled into the tray.