Carmanah E Series 설치 매뉴얼 - 페이지 12

{카테고리_이름} Carmanah E Series에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Carmanah E Series 16 페이지. Rrfb mast arm kit
Carmanah E Series에 대해서도 마찬가지입니다: 빠른 시작 매뉴얼 (20 페이지), 에너지 관리 시스템 교체 매뉴얼 (12 페이지), 설치 매뉴얼 (20 페이지), 사용자 설명서 (18 페이지), 교체 매뉴얼 (9 페이지), 설치 매뉴얼 (18 페이지)

4.2

Antenna

1. Drill a ½" hole on the top of the solar engine enclosure. Deburr hole and remove all aluminum chips.

a. E Series – on the top of the solar engine enclosure, mark a point 1.13" from the back and 1.50"

from the side as shown.

b. F Series – use the half shear indentation to locate the tip of the drill bit.

Ensure the equipment is not powered during installation. Recheck all wiring prior to energizing

the system.

Ensure all metal chips are removed to prevent system damage caused by short circuits.

Ensure that no burrs are present that would interfere with the antenna seal.

2. Route antenna coax connector cables into enclosure hole and through plastic washer, lock washer, and

nut. Tighten nut securely using crescent wrench.

3. Thread 90° coax adapters onto antenna connectors. Orient as shown (facing upward when installed into

solar engine).

4. Thread coax adapters onto AI FCU connectors. Match GPS & LTE labels on antenna harness & AI FCU

(Cell closer to front, GPS closer to back).

Carmanah Technologies Corp. | 250 Bay St, Victoria, BC V9A 3K5, Canada | 1.250.380.0052 |

APPLIED INFORMATION (AI) INTEGRATION

INSTALL GUIDE

carmanah.com