Carmanah E Series 사용자 설명서 - 페이지 15

{카테고리_이름} Carmanah E Series에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Carmanah E Series 18 페이지. Rrfb mast arm kit
Carmanah E Series에 대해서도 마찬가지입니다: 빠른 시작 매뉴얼 (20 페이지), 설치 매뉴얼 (16 페이지), 에너지 관리 시스템 교체 매뉴얼 (12 페이지), 설치 매뉴얼 (20 페이지), 교체 매뉴얼 (9 페이지), 설치 매뉴얼 (18 페이지)

6.4

Adjusting Trigger Output Configuration

Under the "DR600 Setup", "Hardware & IO Config" tab are settings that control the system's activation behavior:

Output Hold Time: this setting controls how long the local (and any remote wirelessly-connected) Carmanah

E/F/G system(s) continue to flash after the radar module stops sensing vehicle motion. Default is 10 seconds. To

avoid erratic flashing, this setting should not be set below 5 seconds.

Trigger Event: this setting changes the conditions under which an activation of the connected Carmanah E/F/G

system is triggered:

None: no activations will occur.

•

Default: Displayed Target Above Speed Limit (default setting): Carmanah E/F/G system

•

activated when vehicle detected above configured Speed Limit on "Detection & Units" tab.

Displayed Target Below Speed Limit: Carmanah E/F/G system activated when vehicle

•

detected below configured Speed Limit on "Detection & Units" tab.

Any Displayed Target: Carmanah E/F/G system activated whenever a vehicle is detected,

•

regardless of speed.

Trigger Direction: this setting changes whether incoming vehicles, outgoing vehicles, or both will trigger the

connected Carmanah E/F/G system. Default setting is Incoming.

Click on "Save Changes" to save the changes to the radar module, or "Close" to disconnect from

the radar module without saving.

Carmanah Technologies Corp. | 250 Bay St, Victoria, BC V9A 3K5, Canada | 1.250.380.0052 |

RADAR DETECTION KIT

carmanah.com