Advanced Keys AK-103 설치 매뉴얼 - 페이지 5

{카테고리_이름} Advanced Keys AK-103에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Advanced Keys AK-103 12 페이지. Intelligent keyless entry system

Main Controller Harness Connection Description

3.2 Accessory Harness (7-Pin) – Connect the following wires

WHITE: (-) Starter Control Relay

• This output is enabled only if a valid access key is detected. This

output can provide Ignition/Starter Control protection or act as an

auxiliary output when valid key is in range. Connect the Starter

Control Relay according to the main controller wiring diagram.

PURPLE: (-) Push-Start Module Control Output

• Connect this output wire to the "PKE Controller Enable Input" on the

Engine Push-Start Ignition Controller. This output continuously send

out encrypted enable signal to the Push-Start Ignition controller when

a valid access key is detected.

BROWN: (+) Brake

• Connect to Brake Switch wire. (+12V when brake depressed, grounded

or float when released)

BLUE: (-) Windows Close Signal

• Connect to the optional auto window closer module directly.

GREEN: (-) / (+) Door Switch

• This wire connects to the vehicle's "door open" signal wire. If you have

a negative-triggered door switch system, directly connect this wire to

the door switch signal wire.

• If you have a positive-triggered door switch, change the jumper

setting in the main controller. (refer to main controller wiring diagram)

RED: (+) ACC

• Connect to a +12V wire when ignition key is in the ACC and ON (RUN)

positions.