Carmanah G Series 설치 매뉴얼 - 페이지 11

{카테고리_이름} Carmanah G Series에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Carmanah G Series 14 페이지. Rrfb mast arm kit
Carmanah G Series에 대해서도 마찬가지입니다: 빠른 시작 매뉴얼 (16 페이지), 매뉴얼 (11 페이지), 에너지 관리 시스템 교체 매뉴얼 (12 페이지), 캐비닛 도어 교체 매뉴얼 (10 페이지), 매뉴얼 (9 페이지), 사용자 설명서 (18 페이지), 매뉴얼 (10 페이지), 매뉴얼 (10 페이지), 설치 매뉴얼 (18 페이지)

4. Install green wire ring terminal from AI harness along with door ground ring terminal in the order shown

below.

5. Route ground wire down and fasten with screw mount cable tie. Remove existing cable tie if present and

add existing wires to new cable tie

6. Fasten harness wires using two cable ties. Include door switch wire if present.

7. Thread two 90° coax adapters onto antenna connectors. Orient as shown (facing upward when installed

into cabinet).

8. Fasten AI FCU into cabinet using four screws.

9. Thread coax adapters onto AI FCU connectors. Match GPS & LTE labels on antenna harness & AI FCU

(Cell closer to front, GPS closer to back).

10. Route the coax cables between the AI FCU and antenna neatly. Avoid sharp bends in the coax cable.

Keep coax cable away from sharp edges.

11. Mate 16-pin connector to AI FCU connector. With all cables installed, tighten and trim all cable ties.

Carmanah Technologies Corp. | 250 Bay St, Victoria, BC V9A 3K5, Canada | 1.250.380.0052 |

APPLIED INFORMATION (AI) INTEGRATION

Clearance between

coax and box edge

INSTALL GUIDE

carmanah.com