Andea Electronics RL863 사용자 설명서 - 페이지 15

{카테고리_이름} Andea Electronics RL863에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Andea Electronics RL863 18 페이지. Micro-power multi-protocol reader

After the above steps, you can read and write tags, as shown below:

Steps:

1) Set the data block of the tag to be operated in the Addr drop-down box and the

Num drop-down box. After setting, the operable data block is displayed in green

indicating that it can be operated;

2) Click [Read Block] to read the data value of the data block selected in step 1;

3) Write the value in the line (green area) of the data block whose value should be

written, and then click [Write Block];

4) After the operation is completed, click the [Disconnect] button to disconnect the

tag connection.

6. Troubleshooting Of FAQs

1. The indicator of the reader is off:

Failure analysis:

1)There is a problem or poor contact in the reader's communication interface;

2)The reader indicator is broken.

Troubleshooting method: reconnect the reader or change a USB cable to connect

the reader:

1) The indicator is off and the reader does not work. It may be the reader MCU

failure;

Guangzhou Andea Electronics Technology Co., Ltd.

http://www.gzandea.com

Figure 13 Single tag reading and writing steps

User manual

12/15