ATI Technologies ATP 7500 소유자 매뉴얼 - 페이지 4

{카테고리_이름} ATI Technologies ATP 7500에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. ATI Technologies ATP 7500 20 페이지. Digital preamplifier-processor
ATI Technologies ATP 7500에 대해서도 마찬가지입니다: 소유자 매뉴얼 (20 페이지)

페이지 인쇄

General Recommendations

Before you begin the SETUP, we strongly recommend that you

take a few moments to:

• Familiarize yourself with the controls and functions of the

preamplifier-processor.

• Carefully study the system connection diagrams and basic

operational instructions.

• Fully understand the setup and programming instructions.

Front Panel Controls

A Power Switch

Switches the unit into standby mode and the LED turns on.

Do not use this switch to turn the unit off; use the OFF button.

PLEASE NOTE: TO TURN THE UNIT ON, YOU MUST

SELECT A SOURCE EITHER ON THE FRONT PANEL

OR THE REMOTE CONTROL.

B Source Buttons

When a source button is pressed, that source is selected

and the unit is turned on from the STANDBY mode.

C Seek Up

Advances the tuner to the next higher valid station.

D Volume Up

Raises the volume in 1dB increments. The volume will

increase faster if the button is held down.

E 7.1

Selects multi-channel audio and DVD Video.

Page 4

All manuals and user guides at all-guides.com

Precautions

• Install the ATP7500 on a solid shelf.

• Be sure that the area surrounding the unit is well

ventilated and not near a heat source of any kind.

• Prevent any moisture from entering the unit.

• Do not place anything on top of the unit.

• Make all connections BEFORE you turn the unit on.

F AM/FM

Selects AM or FM reception.

G Seek Down

Advances the tuner to the next lower valid station.

H Volume Down

Lowers the volume in 1dB increments. The volume will

decrease faster if the button is held down.

I Zone 2

Toggles the CD, TAPE, TUNER, AUX source buttons, AM/FM,

VOLUME, MUTE, SEEK, and OFF to control ZONE2. If no

settings are selected, the display will default to MAIN ZONE.

J Mute

Toggles the muting for MAIN ZONE and ZONE2.

K Off

Turns the system from ON to Standby.