Dreaming Robots Electric Eel Wheel Nano 2 사용자 설명서 - 페이지 8

{카테고리_이름} Dreaming Robots Electric Eel Wheel Nano 2에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Dreaming Robots Electric Eel Wheel Nano 2 12 페이지.

Threading the Flyer

Tie a piece of yarn onto your bobbin disk as shown below so it can't

slip. You will use this yarn as a leader for your roving. Thread this

lead yarn through the hooks on the flyer arms. Then use the orifice

hook to pull the leader out to the front of the wheel. Attach your

spinning fiber to the lead yarn and you are ready to spin.

Adjusting the Flyer Hooks

When you have spun enough yarn to form a bump on the bobbin, it

is time to slide the flyer hooks. Stop the EEW from spinning by using

the speed control or USB switch. Once the flyer has stopped

moving, adjust the sliding hook to a new position so the bobbin fills

evenly. You don't need to move the front sliding hook. If the flyer

vibrates at higher speeds, position the back flyer hooks evenly so

the flyer is balanced (see the FAQ for more details).