Advanced Keys AK-PSB05 설치 매뉴얼 - 페이지 5

{카테고리_이름} Advanced Keys AK-PSB05에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Advanced Keys AK-PSB05 15 페이지. Push-start ignition system

페이지 인쇄

ACCESSORY HARNESS WIRING DESCRIPTIONS

Accessory Harness 10-Pin 22 Gauge

Orange

OUTPUT

This wire provides a constant 250mA positive output while the system is in ACC, ON and START states.

The output can be used to activate external relays, bypass device and bypass (+)type keysense input etc.

INPUT

Red

Pre-connected to the external backup relays. This output provides constant +12v for ON 1 and ON 2

backup relays.

OUTPUT

Grey

This output provides a constant 500mA negative output while the system is in ACC, ON (RUN) and

START states. This output activates 0.5 seconds before ACC and it can be used to activate external

relays, bypass devices and bypass (-)type keysense input etc.

INPUT

White

Required for remote start function only. Connect this input to a ground source when vehicle is in PARK or

NEUTRAL gear position. This will prevent the vehicle from remote started while in a drive gear. See

Remote Start Function on page 9 for more information on connect and test this input.

IMPORTANT:

Perform Neutral Safety Switch Testing under the Remote Start Function section to verify

switch input is functional by prevent vehicle remote started in drive gear.

INPUT

Purple

Note:

Depending on Jumper Setting (JP2), this input can connect to a externally ground signal from other

device/system to enable this system. See Jumper Setting under Installation Note for more information.

Pink

INPUT

Optional for remote start function only. Connect to the negative side of the Glow Plug Light. This input

will monitor the Glow Plug Light for Diesel Engine and it will wait up to 18 seconds until the Glow Plug

Light goes out before starting the engine.

INPUT

Brown

Connect to Brake Switch wire which sees +12V when brake depressed, grounded or float when

released.

Note:

this input is required for engine start, stop and programming, therefore it is essential that it is

proper installed and tested before starting this system.

OUTPUT

Blue

Pre-connected to the external backup ignition ON 2 relays. This output turn on backup ignition ON 1 relay

OUTPUT

Green

Pre-connected to the external backup ignition ON 1 relays. This output turn on backup ignition ON 1 relay

INPUT

Yellow

Connect this input to a suitable Tach or engine RPM signal source with at least 3 volts (AC) and 20 Hz or

output, negative side of an injector, ignition coil or at the Engine Control Module (ECM).

Note:

this input need not be connected when jumper (JP1) selects Non -Tach Ignition mode. In Non-Tach

Ignition mode, engine START or crank time is depended on how long the push-button is held it down.

250mA

Bypass Module Control

Backup Relay +12v

500mA

Ground-When-Running

Neutral Safety Switch

Push-Start Enable

Wait-to-Start

Note:

this input is not required for non-diesels vehicle.

Brake Input

250mA

ON 2 Backup Relay Control

250mA

ON 1 Backup Relay Control

Engine Tach

OPTIONAL

REQUIRED

JP2

-104 Smart Key module.

OPTIONAL

REQUIRED

OPTIONAL

JP1

OPTIONAL