ANDELI TIG-250PL ACDC 운영자 매뉴얼 - 페이지 13

{카테고리_이름} ANDELI TIG-250PL ACDC에 대한 운영자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. ANDELI TIG-250PL ACDC 20 페이지. Inverter ac/dc pulsed tig welder

shown as the right figure.

If the welder is over-heat, the IGBT over-heat protection unit inside it will output an

instruction to cut output welding current, and brighten the over-heat pilot lamp on the front

panel. At this time, the machine should be relaxed for 15 minutes to cool the fan. When

operating the machine again, the welding output current or the duty cycle should be reduced.

3.3 Movement and placement

Please take care for the welder when moving it, and do not make it sloped.

It also can be moved by the handle on the top of the welder. Place the welder well when

moving it to the right position. When the machine gets to the destination, it needs to be fixed up

to avoid gliding.

When using forklift, its arm length must be long enough to reach the outside so as to ensure

lifting safely.

The movement may result in the potential danger or substantive hazard, so please make

sure that the machine is on the safe position before using it.

TIG-250PL welding machines' power supply connects to 220V.

When the power supply voltage is over the safe work voltage, there are over voltage and

under voltage protection inside the welder, the alarm light will on, at the same time, the current

output will be cut off.

If the power supply voltage continually goes beyond the safe work voltage range, it will

shorten the welder life-span. The below measures can be used:

Change the power supply input net. Such as, connect the welder with the stable power



supply voltage of distributor;

Induce the machines using power supply in the same time;



INSTALLATION AND ADJUSTMENT