Carmelli NG2520PB 조립 지침 매뉴얼 - 페이지 5
{카테고리_이름} Carmelli NG2520PB에 대한 조립 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Carmelli NG2520PB 12 페이지. Hustler 7' & 8' pool table
Carmelli NG2520PB에 대해서도 마찬가지입니다: 조립 지침 매뉴얼 (9 페이지)
페이지 인쇄
ASSEMBLY INSTRUCTIONS
1. Begin LEG assembly by attaching the LEG TOP BOARD #4 and LEG BASE BOARD #5 to the cleats
on two LEG SIDES #2, using the pre-drilled holes with 1-5/8" SCREWS #7, as shown below.
Attach LEG PANEL #3 to the assembled leg frame, using pre-drilled holes, with FLAT HEAD SCREW #16.
Do NOT overtighten screws. Repeat assembly for remaining LEG.
#7
Note: The Leg assembly may require two individuals, one to hold pieces, while the other inserts screws.
TIP: If you hand insert all screws, on a single piece, into pre-drilled holes before tightening, it will help
hold the pieces in alignment as you tighten the screws.
2. Attach each assembled LEG to the bottom of the TABLE BODY #1 with LARGE BOLT #15 and
5/16" FLAT WASHER #6.
3. Thread two LEG LEVELERS #14 on to the bottom of each LEG. Carefully turn table over.
#7
#5
#7
#2
#2
#4
#7
#1
#
16
#3
#14
#6
#15
#3
#2
5