Formula Sound FSM8PLUS 사용자 설명서 - 페이지 3

{카테고리_이름} Formula Sound FSM8PLUS에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Formula Sound FSM8PLUS 8 페이지. 1ru mixer

INSTALLATION

Decide what configuration you require for the FSM 8PLUS, if it is different to the factory setting

follow the instructions below, otherwise go to the set up section.

To change the internal settings first ensure mains power is disconnected, then remove 3 screws

from each side of the top cover and 2 screws from the top of the top cover (8 screws total, retain

for refitting).

The setting of the options is described below with references to drawing 1018 later in the

manual for the positions of the relevant jumpers.

Microphones and/or mono line inputs

For setting mono line inputs move the appropriate jumpers shown in drawing 1018 fig B.

To set channel 5 and/or channel 6 to microphone input set the appropriate switch(es) on the

rear panel adjacent to the channel 5 inputs.

If channel 5 and/or channel 6 is set to microphone they may be routed to the microphone

equalisation by moving the appropriate jumpers shown in drawing 1018 fig E.

For microphones requiring phantom power (including channels 5 & 6 if selected) move the

appropriate jumpers shown in drawing 1018 fig B.

Auxiliary and monitor selection

The setting of auxiliary or monitor selection is by moving the appropriate jumpers shown in

drawing 1018 fig C.

To select pre or post fade move the appropriate jumpers shown in drawing 1018 fig D and fig F.

Bass level select

The bass output level may be increased by 6dB by moving the jumper shown in drawing 1018

fig G to the "HI" position.

Stereo or mono main output

The main output may be set to mono by moving the jumper shown in drawing 1018 fig H.

Priority Input

The priority input is on the rear panel 3 pin connector located between the inputs for channels 7

and 8. This is a stereo input (for mono link pins 2 and 3). This could be a jukebox or any other

input that needs to take priority, a pre-set gain trimmer accessible through a hole above the

connector is provided to adjust the level.

An internal sensitivity pre-set is also provided for this input, see drawing 1018 fig L.

When a priority signal is present all other music signals cut. When the priority signal is no longer

present the other music signals will fade back. There is a delay before fade back to ensure

pauses are not treated as end of signal. The voice override facility still functions when the

priority input is in use.