Formula Sound NN106 사용자 설명서 - 페이지 9
{카테고리_이름} Formula Sound NN106에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Formula Sound NN106 18 페이지. Multi input mixer
페이지 인쇄
AUX
The AUX contains a summed signal of each channel with AUX selected, the level of
the summed AUX 1 signal is adjusted by the volume control marked AUX. The AUX
signal is balanced stereo on a pair of ¼" jack sockets.
ZONE output
A balanced stereo zone output is provided on a 6 pin rectangular connector, the zone
output is controlled by a remote panel (not included) that connects to an adjacent 3
pin rectangular connector.
Balanced Zone output on the 6 way connector, left pin 1 + pin 2 0V/grnd Pin 3 -,
right pin 4 + pin5 0V/grnd pin 6 -.
The remote panel (not included) may be located up to 30 metres from the mixer and
allows the zone volume to be controlled entirely separately.
Remote panel pin 3 is 0V/grnd, pin 2 and 1 connect to the wiper of the pot providing
the volume control.
Crossfader
The crossfader has signals assigned to it by the XFA and XFB controls on input
channels 1 – 6. If multiple XFA and/or XFB switches are selected then those signals
are summed at the crossfader.
XFA signals are sent to the left of the cross fader and XFB signals are sent to the
right of the cross fader. If one or both sides has no signals assigned then that side will
have no signal.
The signal from the crossfader that is routed to the output is dependent on the
position of the crossfader, with crossfader set full left any XFA selection is sent to the
output and with the crossfader full right any XFB selection is sent to the output.
With the crossfader in centre position equal amounts of XFA and XFB will be sent to
the output, with the crossfader off to one side (but not at end) a mix of XFA and XFB
will be sent to the output. The relative level of XFA and XFB will depend on the
position of the crossfader, more to the left and XFA will be larger and more to the
right and XFB will be larger.
The rate at which the signal changes from XFA to XFB as the crossfader moves left
to right (or vice versa) can be adjusted by the contour control.
A recessed switch in the base of the unit can switch the crossfader off.